wips

interface-config-radio-instance

Enables access point to change its channel of operation in order to terminate rogue devices. The radio should be configured to provide WLAN service.

This option is enabled by default.

Supported in the following platforms:

  • Access Points — AP505i, AP510i, AP510e, AP560i, AP560h

Syntax

Note

Note

WiNG access points use Smart RF to perform off-channel scans. Therefore, ensure that a Smart RF policy is configured and applied to the access points RF Domains to enable them perform rogue detection and termination.
wips airtime-termination [allow-channel-change|spectrum-management-strict]

Parameters

wips airtime-termination [allow-channel-change|spectrum-management-strict]
wips airtime-termination allow-channel-change Enables access point to change its channel of operation (to that of the rogue device) in order to terminate the rogue device
spectrum-management-strict Enables the processing of spectrum management capability of an AP before performing air-termination

Example

nx9500-6C8809(config-profile-testAP510-if-radio1)#wips air-termination allow-channel-change

Related Commands

no (radio-interface-config-command) Disables access point to change its channel of operation in order to terminate rogue devices