Print this pagePrint this page

Email this topicEmail this topic

View PDFView PDF

Download EPUBDownload EPUB

macauth

Displays details of wired ports that have MAC address authentication enabled.

Use this command to view MAC authentication configuration and authentication state. The command displays the current authentication state of the wired host, the authorization state of the Ge1 port, and the wired hosts‘ MAC address. The port status displays as Authorized if the wired host has successfully authenticated and Not Authorized if the wired host has not authenticated or has failed MAC authentication.

For more information on enabling MAC address authentication on a wired port, see mac-auth (profile-config-mode).

Supported in the following platforms:

  • Access Points — AP505i, AP510i/e, AP560i/h
  • Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax 

show mac-auth {all|interface|on}
show mac-auth {all|interface [<INTERFACE-NAME>|ge <1-5>|port-channel <1-3>|
t1e1 <1-4>|up <1-2>|xge <1-4>]} {(on <DEVICE-NAME>)}

Parameters

show mac-auth {all|interface [<INTERFACE-NAME>|ge <1-5>|port-channel <1-3>|
t1e1 <1-4>|up <1-2>|xge <1-4>]} {(on <DEVICE-NAME>)}
macauth Displays MAC authentication related information for all interfaces or a specified interface
all
  • Displays MAC authentication related information for all interfaces
interface [<INTERFACE-NAME>|ge <1-5>| port-channel <1-3>| t1e1 <1-4>|up <1-2>| xge <1-4>]

Optional. Displays MAC authentication related information for a specified interface. Specify the interface using one of the following options:

  • <INTERFACE-NAME> – Selects the interface identified by the <INTERFACE-NAME> keyword
  • ge <1-5> – Selects the GigabitEthernet interface identified by the index number
  • port-channel <1-3> – Selects the port channel interface identified by the index number
  • t1e1 <1-4> – Selects the layer 2 interface (Ethernet port)
  • up <1-2> – Selects the WAN Ethernet interface identified by the index number
  • xge <1-4> – Selects the TenGigabitEthernet interface identified by the index number
on <DEVICE-NAME> The following keywords are common to the ‘all‘ and ‘interface‘ parameters:
  • on <DEVICE-NAME> – Optional. Displays MAC authentication related information on a specified device
  • <DEVICE-NAME> – Specify the name of the AP, wireless controller, or service platform.
Note: When the ‘on‘ keyword is used exclusively, without the ‘all‘ and ‘interface‘ options, the system displays MAC authentication related information for interfaces configured on the specified device.

Examples

rfs4000-229D58(config)#show mac-auth all
AAA-Policy is none

Mac Auth info for interface GE1
-----------------------------------
 Mac Auth Enabled
 Mac Auth Not Authorized

Mac Auth info for interface GE2
-----------------------------------
 Mac Auth Disabled
 Mac Auth Not Authorized

Mac Auth info for interface GE3
-----------------------------------
 Mac Auth Disabled
 Mac Auth Not Authorized

Mac Auth info for interface GE4
-----------------------------------
 Mac Auth Disabled
 Mac Auth Authorized

Mac Auth info for interface GE5
-----------------------------------
 Mac Auth Disabled
 Mac Auth Not Authorized

Mac Auth info for interface UP1
-----------------------------------
 Mac Auth Disabled
 Mac Auth Not Authorized
rfs4000-229D58(config)#
Published July 2019prev | next

Email this topicEmail this topic

Print this pagePrint this page