udp

Configures MiNT UDP/IP encapsulation parameters. Use this command to configure the default UDP port used for MiNT control packet encapsulation.

Supported in the following platforms:

  • Access Points — AP505i, AP510i/e, AP560i/h
  • Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

udp port <2-65534>

Parameters

udp port <2-65534>

port <2-65534>

Configures default UDP port used for MiNT control packet encapsulation

  • <2-65534> – Enter a value from 2 - 65534. This value specifies an alternate UDP port used by MiNT control packets and must be an even number. The specified port number plus 1 is used to carry MiNT data packets. The default value is 24576.

Examples

nx9500-6C8809(config-mint-policy-global-default)#udp port 1024
nx9500-6C8809(config-mint-policy-global-default)#show context
mint-policy global-default
 udp port 1024
 mtu 996
 level 2 area-id 2000
 sign-unknown-device
 security-level control-and-data
 rejoin-timeout 1000
nx9500-6C8809(config-mint-policy-global-default)#

Related Commands

no

Reverts MiNT UDP/IP encapsulation to its default