radio-resource-measurement

interface-config-radio-instance

Enables 802.11k radio resource measurement. When enabled, the radio station sends channel and neighbor reports.

The IEEE 802.11 Task Group k defined a set of specifications regarding radio resource measurements. These specifications specify the radio resources to be measured and the mechanism used to communicate measurement requests and results.

Supported in the following platforms:

  • Access Points — AP505i, AP510i, AP510e, AP560i, AP560h

Syntax

radio-resource-measurement [attenuation-threshold <1-199>|max-entries <1-12>]

Parameters

radio-resource-measurement [attenuation-threshold <1-199>|max-entries <1-12>]
radio-resource-measurement Enables 802.11k radio resource measurement on the radio
attenuation-threshold <1-199> Configures the neighbor attenuation threshold, considered when generating channel and neighbor reports
  • <1-199> – Specify the attenuation threshold from 1 -199. The default is 90.
max-entries <1-12> Configures the maximum number of entries to include in channel and neighbor reports
  • <1-12> – Specify a value from 1 - 12. The default is 6.

Example

ap505-133E1C(config-profile-testap505-if-radio2)##radio-resource-measurement attenuation-threshold 150

ap505-133E1C(config-profile-testap505-if-radio2)#radio-resource-measurement max-entries 10

ap505-133E1C(config-profile-testap505-if-radio2)#show context
 interface radio2
  mesh client
  beacon period 50
  antenna-elevation 5.0
  antenna-gain 12.0
  off-channel-scan
  aggregation ampdu tx-only
  association-list global test
  aeroscout forward ip 1.23.4.56 port 300
  antenna-mode 2x2
  antenna-diversity
  radio-resource-measurement max-entries 10
  radio-resource-measurement attenuation-threshold 150
  assoc-response rssi-threshold -128
  bridge ssid test
  mu-mimo
  ldpc
  lock-rf-mode
  fallback-channel 104
ap505-133E1C(config-profile-testap505-if-radio2)#

Related Commands

no (radio-interface-config-command) Disables 802.11k radio resource measurement support