neighbor-info-interval

Profile Config Commands

Configures the neighbor information exchange interval

Supported in the following platforms:

  • Access Points — AP505i, AP510i/e, AP560i/h
  • Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

neighbor-info-interval <1-100>

Parameters

neighbor-info-interval <1-100>
<1-100> Sets interval from 1 - 100 seconds. The default is 10 seconds.

Example

nx9500-6C8809(config-profile-default-rfs4000)#neighbor-info-interval 6

nx9500-6C8809(config-profile-default-rfs4000)#show context
profile rfs4000 default-rfs4000
 mint link ip 1.2.3.4
 mint level 1 area-id 88
 bridge vlan 1
  bridging-mode isolated-tunnel
  ip igmp snooping
  ip igmp snooping querier
 neighbor-info-interval 6
 neighbor-inactivity-timeout 500
 autoinstall configuration
 autoinstall firmware
 crypto ikev1 policy ikev1-default
  isakmp-proposal default encryption aes-256 group 2 hash sha
 crypto ikev2 policy ikev2-default
  isakmp-proposal default encryption aes-256 group 2 hash sha
 crypto ipsec transform-set default esp-aes-256 esp-sha-hmac
 crypto ikev1 remote-vpn
 crypto ikev2 remote-vpn
 crypto auto-ipsec-secure
 interface me1
 interface ge1
  ip dhcp trust
  qos trust dscp
--More--
nx9500-6C8809(config-profile-default-rfs4000)#