smart-rf-policy commands

The following table summarizes Smart RF policy configuration commands:
Click to expand in new window

Smart-RF-Policy Config Mode Commands

Command Description
area Configures the channel list and power for a specified area
assignable-power Specifies the power range during power assignment
avoidance-time Allows Smart RF-enabled radios to avoid DFS (Dynamic Frequency Selection) and/or adaptivity regulated channels on detection of interference or radar. This command configures the period for which the channel is avoided.
channel-list Assigns the channel list for the selected frequency
channel-width Selects the channel width for Smart RF configuration
coverage-hole-recovery Enables recovery from errors
enable Enables the Smart RF policy
group-by Configures grouping parameters
interference-recovery Enables recovery from excessive noise and interference related issues
neighbor-recovery Enables recovery from faulty neighbor radios related issues
select-shutdown Enables selection and shutting down of 2.4 GHz radios, causing interference, in case the CCI (co-channel interference) value exceeds a specified threshold
sensitivity Configures Smart RF sensitivity parameters
smart-ocs-monitoring Applies smart OCS (off-channel scanning) instead of dedicated detectors
no (smart-rf-policy-config-mode-command) Negates a command or reverts settings to their default
Note

Note

For more information on common commands (clrscr, commit, help, revert, service, show, write, and exit), see Common Commands.
Note

Note

The input parameter <HOSTNAME>, wherever used in syntaxes across this chapter, cannot include an underscore (_) character. In other words, the name of a device cannot contain an underscore.