no

crypto-auto-ipsec-tunnel commands

Removes or resets this auto IPSec tunnel settings

Supported in the following platforms:

  • Access Points — AP505i, AP510i/e, AP560i/h
  • Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

no [groupid|ike-lifetime|ikev2 peer reauth|ip nat crypto]

Parameters

no <PARAMETERS>
no <PARAMETERS> Removes or resets this auto IPSec tunnel‘s settings based on the parameters passed

Example

The following example shows the Auto IPSec VLAN bridge settings before the ‘no‘ command is executed:

nx9500-6C8809(config-profile-default-rfs4000-crypto-auto-ipsec-secure)#show context
 crypto auto-ipsec-secure
  groupid testpassword@123 rsa
nx9500-6C8809(config-profile-default-rfs4000-crypto-auto-ipsec-secure)#

nx9500-6C8809(config-profile-default-rfs4000-crypto-auto-ipsec-secure)#no groupid

The following example shows the Auto IPSec VLAN bridge settings after the ‘no‘ command is executed:

nx9500-6C8809(config-profile-default-rfs4000-crypto-auto-ipsec-secure)#show context
 crypto auto-ipsec-secure
nx9500-6C8809(config-profile-default-rfs4000-crypto-auto-ipsec-secure)#