guest-management-policy
Configures a guest
management policy that redirects guest users to a registration portal upon
association to a captive portal. Guest users are redirected to an
internally (or) externally hosted registration page (registration.html)
where previously, not-registered guest users can register. The internally
hosted captive portal registration page can be customized based on
business requirements.
Use the guest management policy commands to
configure parameters, such as E-mail host and SMS gateway along with the
credentials required for sending pass code to guest via e-mail and SMS.
You can configure up to 32 different guest management policies. Each
guest management policy allows you to configure the SMS gateway, SMS
message body, E-mail SMTP server, E-mail subject contents, and E-mail
message body. Although, at any point-in-time, multiple guest management
policies may exist, only one guest management policy can be active per
device.
Guest registration is supported only on the NX9500 and
NX7500 series service platforms. However, the number of user identity
entries supported on each varies. It is 2 million and 1 million
user-identity entries for the NX9500 and NX7500 model service platforms
respectively.
Supported in the following platforms:
- Service Platforms —
NX7500, NX9500, NX9600, VX9000
Syntax
guest-management <POLICY-NAME>
Parameters
guest-management <POLICY-NAME>
<POLICY-NAME> |
Specify the guest management policy name. If the policy
does not exist, it is created. |
|
Examples
nx9500-6C8809(config)#guest-management guest
nx9500-6C8809(config-guest-management-guest)#?
Guest Management Mode commands:
email Email guest-notification configuration
guest-database-backup Configure guest-database-backup parameters
guest-database-export Configure guest-database-export parameters
no Negate a command or set its defaults
sms SMS guest-notification configuration
sms-over-smtp Sms-over-smtp configuration to email sms gateway
address
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
nx9500-6C8809(config-guest-management-guest)#
Related Commands
no |
Removes an existing guest management policy |
|