Configures RADIUS user group and enters its configuration mode

Supported in the following platforms:

  • Access Points — AP505i, AP510i/e, AP560i/h
  • Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000


radius-group <RADIUS-GROUP-NAME>


radius-group <RADIUS-GROUP-NAME>
<RADIUS-GROUP-NAME> Specify a RADIUS user group name. The name should not exceed 64 characters. If a RADIUS user group with the specified name does not exist, it is created.


nx9500-6C8809(config)#radius-group testRadiusGr
Radius user group configuration commands:
  guest       Make this group a Guest group
  no          Negate a command or set its defaults
  policy      Radius group access policy configuration
  rate-limit  Set rate limit for group

  clrscr      Clears the display screen
  commit      Commit all changes made in this session
  do          Run commands from Exec mode
  end         End current mode and change to EXEC mode
  exit        End current mode and down to previous mode
  help        Description of the interactive help system
  revert      Revert changes
  service     Service Commands
  show        Show running system information
  write       Write running configuration to memory or terminal


Related Commands

no Removes an existing RADIUS group


For more information on RADIUS user group commands, see RADIUS Policy.