Sets the GRE tunnel‘s DSCP / 802.1q priority value from encapsulated packets to the outer packet IPv4 header.

This option is disabled by default.

Supported in the following platforms:

  • Access Points — AP505i, AP510i/e, AP560i/h
  • Service Platforms — NX5500, NX7500, NX7510, NX7520, NX7530, NX9500, NX9510, NX9600, VX9000


dscp [<0-63>|reflect]


dscp [<0-63>|reflect]
dscp <0-63> Specifies the DSCP 802.1q priority value for outer packets from 0 - 63. The default is 1.
dscp reflect Copies the DSCP 802.1q value from inner packets


rfs4000-229D58(config-device 00-23-68-22-9D-58-gre-tunnel-testGRETunnel)#dscp 20

rfs4000-229D58(config-device 00-23-68-22-9D-58-gre-tunnel-testGRETunnel)#show context
 gre tunnel testGRETunnel
  dscp 20
rfs4000-229D58(config-device 00-23-68-22-9D-58-gre-tunnel-testGRETunnel)#

Related Commands

no Removes the GRE tunnel settings based on the parameters passed