neighbor (meshpoint-config)

This command configures the inactivity time out value for neighboring devices. If a frame is not received from the neighbor device for the configured time, then client resources are removed.

Configured on WiNG 7.1.X controller and pushed to the following WiNG 5.9.X APs:

  • Access Points — AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP7632, AP7662, AP8163, AP8543, AP8533

Syntax

neighbor inactivity-timeout <60-86400>

Parameters

neighbor inactivity-timeout <60-86400>

neighbor inactivity-timeout <60-86400>

Configures the neighbor inactivity timeout in seconds. This represents the allowed interval between frames received from a neighbor before their client privileges are revoked.

  • <60-86400> – Specify a value from 60 - 86400 seconds. The default is 120 seconds.

Examples

nx9500-6C8809(config-meshpoint-test)#neighbor inactivity-timeout 300
nx9500-6C8809(config-meshpoint-test)#show context
meshpoint test
 description "This is an example of a meshpoint description"
 meshid TestingMeshPoint
 beacon-format mesh-point
 control-vlan 25
 allowed-vlans 1,10-16,18-23
 neighbor inactivity-timeout 300
 data-rates 2.4GHz bgn
 data-rates 5GHz an
 security-mode none
 no root
nx9500-6C8809(config-meshpoint-test)#

Related Commands

no (meshpoint-config)

Removes the configured neighbor inactivity time out value for this meshpoint