ip

interface-config-wwan-instance

Configures IP related settings on this interface

Supported in the following platforms:

  • Access Point — AP7161, AP8163
  • Wireless Controllers — RFS4000

Syntax

ip [default-gateway|nat]
ip default-gateway priority <1-8000>
ip nat [inside|outside]

Parameters

ip default-gateway priority <1-8000>
ip Configures IP related settings on this interface
default-gateway priority <1-8000> Configures the default-gateway‘s (learned by the wireless WAN) priority.
  • <1-8000> – Specify a value from 1 - 8000. The default is 3000.
ip nat [inside|outside]
ip Configures IP related settings on this interface
nat [inside|outside] Configures the NAT settings. This option is disabled by default.
  • inside – Marks this WWAN interface as NAT inside. The inside network is transmitting data over the network to its intended destination. On the way out, the source IP address is changed in the header and replaced by the (public) IP address.
  • outside – Marks this WWAN interface as NAT outside. Packets passing through the NAT on the way back to the controller or service platform managed LAN are matched against the records kept by the NAT engine. There, the destination IP address is changed back to the specific internal private class IP address in order to reach the LAN over the network.

Example

nx9500-6C8809(config-profile-testRFS4000-if-wwan1)#ip default-gateway priority 1

nx9500-6C8809(config-profile-testRFS4000-if-wwan1)#ip nat inside

nx9500-6C8809(config-profile-testRFS4000-if-wwan1)#show context
 interface wwan1
  apn AT&T
  auth-type mschap-v2
  crypto map test
  ip nat inside
  ip default-gateway priority 1
nx9500-6C8809(config-profile-testRFS4000-if-wwan1)#

Related Commands

no Removes IP related settings on this interface