Specify the T5
device‘s MAC address. The system enters the identified device‘s
configuration mode. A T5
controller uses the IPX operating system to manage its
connected radio devices, as opposed to the WiNG
operating system used by RFS wireless controllers and NX
service platforms. However, a T5
controller, once enabled as a supported external device, can
provide data to WiNG to
assist in a T5‘s
management within a WiNG
supported subnet populated by both types of devices. The CPEs
(Customer Premises Equipments) are the T5 controller managed radio devices using the IPX
operating system. These CPEs use a DSL (Digital
Subscriber Line) as their high speed Internet access
mechanism using the CPE‘s physical wallplate connection and
phone jack.
After logging on to the T5
device, use the ‘cpe‘ keyword and configure the following
mandatory settings:
- vlan –
Set a VLAN from 1 - 4,094 used as a virtual interface for
connections between the T5
controller and its managed CPE devices.
- start ip
– Set a starting IP address used in a range of addresses
available to T5
controller connecting CPE devices.
- end ip –
Set an end IP address used in a range of addresses
available to T5
controller connecting CPE devices.
|