diag

Profile Config Commands

Enables looped packet logging. When enabled, devices, using this profile, start logging looped packets to a separate queue. This option is disabled by default.

Looped packet logging can also be enabled in the device configuration context.

Note

Note

To view logged looped packets, execute the service > show > diag > pkts command. For more information, see service.

Supported in the following platforms:

  • Access Points — AP505i, AP510i/e, AP560i/h
  • Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

diag pkts

Parameters

diag pkts
diag pkts Enables looped packet logging

Example

nx9500-6C8809(config-profile-default-nx75xx)#diag pkts

nx9500-6C8809(config-profile-default-nx75xx)#show context include-factory | include diag
 diag pkts
nx9500-6C8809(config-profile-default-nx75xx)#

Related Commands

no Disables looped packet logging