service (meshpoint-config)

Use this command to allow only those neighbors who are capable of 802.11n data rates to associate with this meshpoint.

Configured on WiNG 7.1.X controller and pushed to the following WiNG 5.9.X APs:

  • Access Points — AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP7632, AP7662, AP8163, AP8543, AP8533

Syntax

service [allow-ht-only|show cli]

Parameters

service [allow-ht-only|show cli]

service allow-ht-only

Allows only those neighbors who are capable of high throughput data rates (802.11n data rates) to associate with the meshpoint

service show cli

Displays running system configuration

Examples

nx9500-6C8809(config-meshpoint-test)#service allow-ht-only
nx9500-6C8809(config-meshpoint-test)#show context
meshpoint test
 description "This is an example of a meshpoint description"
 meshid TestingMeshPoint
 shutdown
 beacon-format mesh-point
 control-vlan 1
 allowed-vlans 1,10-16,18-23
 neighbor inactivity-timeout 300
 data-rates 2.4GHz bgn
 data-rates 5GHz an
 security-mode psk
 wpa2 psk 0 Test Company
 wpa2 key-rotation unicast 1200
 wpa2 key-rotation broadcast 600
 root
 service allow-ht-only
nx9500-6C8809(config-meshpoint-test)#

Related Commands

no (meshpoint-config)

Removes the restriction that only 802.11n capable neighbor devices can associate with this meshpoint

service (common commands)

Invokes service commands to troubleshoot or debug