nat-pool-config-instance

ip

Use the config-profile-<DEVICE-PROFILE-NAME> instance to configure Network Address Translation (NAT) pool settings.

The following example uses the config-profile-nx9500-6C8809 instance to configure NAT pool settings:

nx9500-6C8809(config-profile-default-rfs4000)#ip nat pool pool1
nx9500-6C8809(config-profile-default-rfs4000-nat-pool-pool1)#

nx9500-6C8809(config-profile-default-rfs4000-nat-pool-pool1)#?
Nat Policy Mode commands:
  address  Specify addresses for the nat pool
  no       Negate a command or set its defaults

  clrscr   Clears the display screen
  commit   Commit all changes made in this session
  do       Run commands from Exec mode
  end      End current mode and change to EXEC mode
  exit     End current mode and down to previous mode
  help     Description of the interactive help system
  revert   Revert changes
  service  Service Commands
  show     Show running system information
  write    Write running configuration to memory or terminal

nx9500-6C8809(config-profile-default-rfs4000-nat-pool-pool1)

The following table summarizes NAT pool configuration commands:

Command Description
address Configures NAT pool addresses
no Negates a command or sets its default