override-smart-rf

Enables dynamic channel switching for Smart RF radios. This command allows you to configure an override list of channels that Smart RF can use for channel compensations on 2.4 GHz and 5.0 GHz radios.

When a radio fails or is faulty, a Smart RF policy provides automatic recovery by instructing neighboring access points to increase their transmit power to compensate for the coverage loss. Once correct access point placement has been established, Smart-RF can optionally be leveraged for automatic detector radio selection. Smart-RF uses detector radios to monitor RF events and can ensure availability of adequate detector coverage.

Supported in the following platforms:

  • Access Points — AP505i, AP510i/e, AP560i/h
  • Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

override-smartrf channel-list [2.4GHz|5GHZ] <CHANNEL-LIST>

Parameters

override-smartrf channel-list [2.4GHz|5GHZ] <CHANNEL-LIST>
override-smartrf Enables dynamic channel switching for Smart RF radios
channel-list Configures a list of channels for 2.4 GHz and 5.0 GHz Smart RF radios
2.4GHz <CHANNEL-LIST> Selects the 2.4 GHz Smart RF radio channels
  • <CHANNEL-LIST> – Specify a list of channels separated by commas.
5GHz <CHANNEL-LIST> Selects the 5.0 GHz Smart RF radio channels
  • <CHANNEL-LIST> – Specify a list of channels separated by commas.

Examples

nx9500-6C8809(config-rf-domain-default)#override-smartrf channel-list 2.4GHz 1,2,3
nx9500-6C8809(config-rf-domain-default)#show context
rf-domain default
 contact Bob+14082778691
 country-code us
 override-smartrf channel-list 2.4GHz 1,2,3
 layout area Ecospace floor Floor1 map-location www.firstfloor.com units meters
nx9500-6C8809(config-rf-domain-default)#

Related Commands

no (rf-domain-config-mode) Removes the override-smartrf list of channels configured for 2.4 GHz and 5.0 GHz radios