eguest-server (NOC Only)

Profile Config Commands

Points to the EGuest server when executed along with the ‘host‘ option. The WiNG EGuest solution is an independently installable VM/Server that provides integrated guest management and analytics. Use this command to enable the EGuest daemon on the EGuest server.

Note

Note

EGuest being a licensed feature, ensure that the EGUEST-DEV license is applied on the EGuest server‘s self context. For more information, see license.

Supported in the following platforms:

  • Access Points — AP505i, AP510i/e, AP560i/h
  • Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

eguest-server <1-3> host <IPv4/IPv6/HOSTNAME> {http|https}

Parameters

eguest-server <1-3> host <IPv4/IPv6/HOSTNAME> {http|https}
eguest-server <1-3> host <IPv4/IPv6/HOSTNAME> {http|https} Configures the EGuest server details in the profile/device context of the NOC (access point/controller). When configured, the NOC posts registration requests and captive-portal related data directly to the specified EGuest server.
  • <1-3> – Configures the EGuest server index number. A maximum of three EGuest servers can be configured.
    • host <IPv4/IPv6/HOSTNAME> – Configures the EGuest server‘s IPv4/IPv6 address or hostname.
      • {http|https} – Optional. Configures the mode of connection as HTTP or HTTPS.
        Note: HTTPS is recommended as it uses encryption for transmission and is therefore more secure.

Example

On the NOC, execute along with the ‘host‘ option to point to the EGuest server.

EG-NOC(config-device-74-67-F7-5C-64-4A)#eguest-server 1 host EG-Server https

EG-NOC(config-device-74-67-F7-5C-64-4A)#show context include-factory | include eguest-server
 no eguest-server
 eguest-server 1 host EG-Server https
EG-NOC(config-device-74-67-F7-5C-64-4A)#

Related Commands

no Removes the EGuest server IP address/hostname configuration