association-acl-policy

Configures an association ACL policy. This policy defines a list of devices allowed or denied access to the network.

Supported in the following platforms:

  • Access Points — AP505i, AP510i/e, AP560i/h
  • Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

association-acl-policy <ASSOCIATION-ACL-POLICY-NAME>

Parameters

association-acl-policy <ASSOCIATION-ACL-POLICY-NAME>

<ASSOCIATION-ACL-POLICY-NAME>

Specify the association ACL policy name. If the policy does not exist, it is created.

Examples

NOC-NX9500(config)#association-acl-policy test
NOC-NX9500(config-assoc-acl-test)#?
Association ACL Mode commands:
  deny     Specify MAC addresses to be denied
  no       Negate a command or set its defaults
  permit   Specify MAC addresses to be permitted

  clrscr   Clears the display screen
  commit   Commit all changes made in this session
  do       Run commands from Exec mode
  end      End current mode and change to EXEC mode
  exit     End current mode and down to previous mode
  help     Description of the interactive help system
  revert   Revert changes
  service  Service Commands
  show     Show running system information
  write    Write running configuration to memory or terminal

NOC-NX9500(config-assoc-acl-test)#

Related Commands

no

Removes this Association ACL Policy

Note

Note

For more information on the association-acl-policy, see Association-ACL Policy.