Profile Config Commands

Sets the floor name where the target device (access point, wireless controller, or service platform using this profile) is physically located. Assigning a building floor name helps in grouping devices within the same general coverage area.

Supported in the following platforms:

  • Access Points — AP505i, AP510i/e, AP560i/h
  • Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000


floor <WORD> {<1-4094>}


floor <WORD> {<1-4094>}
floor <WORD> {<1-4094>} Sets the floor name where the target device is located
  • <WORD> – Specify the floor name (should not exceed 64 characters in length).
    • <1-4094> – Optional. Configures the floor number from 1 - 4094. The default is 1.


nx9500-6C8809(config-profile-default-rfs4000)#floor fifth

nx9500-6C8809(config-profile-default-rfs4000)#show context
profile rfs4000 default-rfs4000
 bridge vlan 1
  ip igmp snooping
  ip igmp snooping querier
 area Ecospace
 floor fifth
 autoinstall configuration
 autoinstall firmware

Related Commands

no Resets the configured floor name and number