ipv6-access-list
Configures an IPv6 ACL. IPv6 ACLs define
a set of rules that filter IPv6 packets flowing through a port or interface. Each rule
specifies the action taken when a packet matches the rule. If the action is deny, the packet
is dropped. If the action is permit, the packet is allowed.
The WiNG software supports IPv6 only on VLAN
interfaces. Therefore, IPv6 ACLs can be applied only on the VLAN interface.
The
following table summarizes IPv6 access list configuration commands:
IPv6 Access List Config Mode
Commands
Command |
Description |
deny (ipv6-acl) |
Creates a deny access rule or modifies an existing rule. A deny access rule
rejects IPv6 packets from specified address(es) and/or destined for specified
address(es). |
permit (ipv6-acl) |
Creates a permit access rule or modifies an existing rule. A permit access
rule accepts IPv6 packets from specified address(es) and/or destined for specified
address(es). |
no (ipv6-acl) |
Removes a deny and/or a access rule from a IPv6 ACL |
|