radius-user-pool-policy

Configures a RADIUS user pool and enters its configuration mode

Supported in the following platforms:

  • Access Points — AP505i, AP510i/e, AP560i/h
  • Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

radius-user-pool-policy <RADIUS-USER-POOL-NAME>

Parameters

radius-user-pool-policy <RADIUS-USER-POOL-NAME>
<RADIUS-USER-POOL-POLICY-NAME> Specify the RADIUS user pool policy name. If a policy with the specified name does not exist, it is created.

Examples

nx9500-6C8809(config)#radius-user-pool-policy testRadiusUserPool
nx9500-6C8809(config-radius-user-pool-testRadiusUserPool)#?
Radius User Pool Mode commands:
  duration  Set a guest user's access duration
  no        Negate a command or set its defaults
  user      Radius user configuration

  clrscr    Clears the display screen
  commit    Commit all changes made in this session
  do        Run commands from Exec mode
  end       End current mode and change to EXEC mode
  exit      End current mode and down to previous mode
  help      Description of the interactive help system
  revert    Revert changes
  service   Service Commands
  show      Show running system information
  write     Write running configuration to memory or terminal

vnx9500-6C8809(config-radius-user-pool-testRadiusUserPool)#

Related Commands

no Removes an existing RADIUS user pool policy
Note

Note

For more information on RADIUS user group commands, see RADIUS Policy.