cdp

interface-config-ge-instance

Enables CDP on the selected GE port

Supported in the following platforms:

  • Access Points — AP505i, AP510i/e, AP560i/h
  • Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

cdp [receive|transmit]

Parameters

cdp [receive|transmit]
receive Enables CDP packet snooping on this interface. When enabled, the port receives periodic interface updates from a multicast address. This option is enabled by default.
transmit Enables CDP packet transmission on this interface. When enabled, the port sends out periodic interface updates to a multicast address to advertise its presence to neighbors. This option is enabled by default.

Example

nx9500-6C8809(config-profile-default-rfs4000-if-ge1)#cdp transmit

Related Commands

no Disables CDP packet snooping on the controller or service platform‘s selected GE ports