peer

crypto-map-ipsec-manual-instance

Sets the peer device‘s IP address. This can be set for multiple remote peers. The remote peer can be an IP address.

Supported in the following platforms:

  • Access Points — AP505i, AP510i/e, AP560i/h
  • Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

peer <IP>

Parameters

peer <IP>
peer <IP> Enter the peer device‘s IP address. If not configured, it implies respond to any peer.

Example

nx9500-6C8809(config-profile-default-rfs4000-cryptomap-map1#1)#peer 172.16.10.12

nx9500-6C8809(config-profile-default-rfs4000-cryptomap-map1#1)#show context
 crypto map map1 1 ipsec-manual
  peer 172.16.10.12
nx9500-6C8809(config-profile-default-rfs4000-cryptomap-map1#1)#