Basic IGMP Configuration describes the basic steps to configure IGMP on S- K- and 7100-Series devices. This procedure assumes that the VLANs on which IGMP will run have been configured and enabled with IP interfaces.
Step | Task | Command |
---|---|---|
1 | In switch mode, configure IGMP for each VLAN interface. | set igmp config vlan-list {[query-interval query-interval] [igmp-version igmpversion] [max-resp-time max-resp-time] [robustness robustness] [last-mem-int last-mem-int] [fast-leave fast-leave] [rtr-alert-checking rtr-alert-checking] [filter-id filter-id] [filter-status {enable | disable}]} |
2 | In switch mode, enable IGMP on each VLAN interface. | set igmp enable vlan-list |
3 | In switch mode, enable IGMP querying on each of the VLANs specified in step 2. | set igmp query-enable vlan-list |
For more information on IGMP CLI commands, refer to S-, K-, and 7100 Series CLI Reference Guide.