PE Router 1 (PE1)
PE1 connects to both customer A and customer B.
In executive command mode, configure SPBV on the router:
- Set Spanning Tree version to SPT
- Configure the Spanning Tree MST configuration name to spbvRegion1
- Configure the SPVID pool for 2000 - 2200 and set the pool to SID spvid (4095)
- Map customer VLANs 100 and 200 to SID spbv (4093)
- For the ECT algorithm, the default value of 1 is used.
- Configure all Global router ports, ge.1.10-20 are enabled for SPBV
On customer A VRF1 configure:
- RD – 1:10
- Route target – export 1:1 and 1:10
On customer 2 VRF2 configure
- RD – 2:20
- Route target – export 2:2 and import 2:2 and 2:20
In the global VRF:
- Configure a loopback interface specifying the global VRF BGP address as primary
- Enable the VPNV4 address family in BGP configuration mode (if using IPv6 enable VPNV6)
- Activate VPNV4 neighbors