Configuring an LSNAT Real Server

Configuring an LSNAT Real Server describes how to configure an LSNAT real server.

Configuring an LSNAT Real Server

Step	Task	Command(s)
1	In SLB server farm configuration command mode, configure the real server members for the IPv4 or IPv6 server farm and enter SLB real server configuration command mode in which the remaining commands in this procedure are configured.	real ip-address [port number]
2	Optionally, apply a configured probe to probe one or probe two to monitor this IPv4 or IPv6 real server. An ICMP ping and TCP or UDP probe can be configured on separate command lines.	faildetect probe {one | two} probe-name
3	Optionally, specify whether the currently configured probes are active or inactive for this IPv4 or IPv6 real server.	faildetect type {none | probe}
4	Optionally, reset fail detection configuration to the factory default settings for this IPv4 or IPv6 real server.	faildetect reset
5	Optionally, limit the maximum number of active connections for this IPv4 or IPv6 real server.	maxconns maximum-number
6	Optionally configure a weight for this IPv4 or IPv6 real server to be used by the round robin load balancing algorithm.	weight weight-number
7	Enable each IPv4 or IPv6 real server for service.	inservice
8	Exit the LSB real server configuration command mode.	exit