The Helper router 2is configured with a VLAN 1 management interface, and VLAN 20 and VLAN 30 for interfaces internal to the SPB network. On both internal VLANs, VRRP is enabled with Helper router mode.
System(rw)->configure System(rw-config)->interface loopback.0.1 System(rw-config-intf-loop.0.0)->ip address 10.1.254.2/32 System(rw-config-intf-loop.0.0)->no shutdown System(rw-config-intf-loop.0.0)->exit System(rw-config)->interface vlan 1 System(rw)-config-intf-vlan.0.1)->description “management” System(rw)-config-intf-vlan.0.1)->ip address 10.1.1.4/24 255.255.255.0 primary System(rw)-config-intf-vlan.0.1)->no ip proxy-arp System(rw)-config-intf-vlan.0.1)->no ip forwarding System(rw)-config-intf-vlan.0.1)->no shutdown System(rw)-config-intf-vlan.0.1)->exit System(rw-config)->interface vlan 20 System(rw)-config-intf-vlan.0.20)->description “spbnetwork20” System(rw)-config-intf-vlan.0.20)->ip address 10.1.20.3/24 System(rw)-config-intf-vlan.0.20)->vrrp create 1 v2-ipv4 System(rw)-config-intf-vlan.0.20)->vrrp address 1 10.1.20.4 System(rw)-config-intf-vlan.0.20)->vrrp accept-mode1 System(rw)-config-intf-vlan.0.20)->vrrp fabric-route-mode 1 helper-router System(rw)-config-intf-vlan.0.20)->vrrp enable 1 System(rw)-config-intf-vlan.0.20)->no shutdown System(rw)-config-intf-vlan.0.20)->exit System(rw-config)->interface vlan 30 System(rw)-config-intf-vlan.0.30)->description “spbnetwork30” System(rw)-config-intf-vlan.0.30)->ip address 10.1.30.3/24 System(rw)-config-intf-vlan.0.30)->vrrp create 1 v2-ipv4 System(rw)-config-intf-vlan.0.30)->vrrp address 1 10.1.30.4 System(rw)-config-intf-vlan.0.20)->vrrp accept-mode 1 System(rw)-config-intf-vlan.0.30)->vrrp fabric-route-mode 1 helper-router System(rw)-config-intf-vlan.0.30)->vrrp enable 1 System(rw)-config-intf-vlan.0.30)->no shutdown System(rw)-config-intf-vlan.0.30)->exit System(rw-config)->