Implementing Flow Setup Throttling
To configure FST for a given port classification:
-
Determine an appropriate flow baseline from which flow limits can be set for each port classification type by monitoring the ports associated with each port classification.
-
Set the low- and high-limit actions to be taken for the specified port classification.
-
Set the ports that will use the configured port classification.
-
Enable FST on all ports configured for flowlimiting.
-
Optionally, enable the sending of SNMP traps action globally on the device.
-
Optionally, enable the disable port action globally on the device.
-
Enable FST on the device.
-
Verify the configuration or monitor baseline configurations using the FST show commands.