Basic MLD Configuration describes the basic steps to configure MLD on S- K- and 7100-Series devices. This procedure assumes that the VLANs on which MLD will run have been configured and enabled with IP interfaces.
Step | Task | Command |
---|---|---|
1 | In switch mode, configure MLD for each VLAN interface. | set mld config vlan-list {[query-interval query-interval] [mld-version mldversion] [max-resp-time max-resp-time] [robustness robustness] [last-mem-int last-mem-int]} |
2 | In switch mode, enable MLD on each VLAN interface. | set mld enable vlan-list |
3 | In switch mode, enable MLD querying on each of the VLANs specified in step 2. | set mld query-enable vlan-list |
For more information on MLD CLI commands, refer to S-, K-, and 7100 Series CLI Reference Guide.