Source and destinations addresses need to be configured for the IKE map. The source address is the local address. The destination address is the remote address. Both IPv4 and IPv6 addresses are supported. Address ranges are supported using the slash (/) length notation.
Use the dst command in IKE map configuration mode to configure a destination address for the IKE map.
Use the src command in IKE map configuration mode to configure a source address for the IKE map.
The default SA port for the IKE map is any port. The source and destination ports can be specified for the SA when a specific protocol such as UDP is being authenticated. If you wish to limit the IKE map to a specific port, configure the source and destination port.
Use the dst-port command in IKE map configuration mode to configure the IKE map for a specific destination port.
Use the src-port command in IKE map configuration mode to configure the IKE map for a specific source port.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB