CLI Input for PE2

SPBV:

PE1(su)->set spantree version spt
PE1(su)->set spantree mstcfgid cfgname spbvRegion1
PE1(su)->set spantree mstmap 2000-2200 sid spvid
PE1(su)->set spantree mstmap 100,200 sid spbv
PE1(su)->set spb port ge.1.10-20 status enable

VRF3:

PE2(su)->router vrf3
PE2(su-vrf3)->configure
PE2(su-vrf3-config)->rd 2:21
PE2(su-vrf3-config)->route-target both 2:20
PE2(su-vrf3-config)->route-target import 2:2
PE2(su-vrf3-config)->exit
PE2(su-vrf3)->exit

VRF4

PE2(su)->router vrf4
PE2(su-vrf4)->configure
PE2(su-vrf4-config)->rd 1:11
PE2(su-vrf4-config)->route-target both 1:10
PE2(su-vrf4-config)->route-target import 1:1
PE2(su-vrf4-config)->exit
PE2(su-vrf4)->exit

Global VRF

Use the following example input when configuring L3 VPN over SPBV.

PE1(su)->configure
PE1(su-config)->interface loopback 1
PE1(su-config-intf-loop.0.1)->ip address 192.168.100.20 255.255.255.255 primary
PE1(su-config-intf-loop.0.1)->no shutdown
PE1(su-config-intf-loop.0.1)->exit
PE1(su-config)->interface vlan 100
PE1(su--config-intf-vlan.0.100)->ip address 192.168.100.112 255.255.255.0 primary
PE1(su--config-intf-vlan.0.100)->no shutdown
PE1(su--config-intf-vlan.0.100)->exit
PE1(su-config)->interface vlan 200
PE1(su--config-intf-vlan.0.200)->ip address 192.168.100.122 255.255.255.0 primary
PE1(su--config-intf-vlan.0.200)->no shutdown
PE1(su--config-intf-vlan.0.200)->exit

Global VRF (BGP)

PE2(su-config)->router bgp 64520
PE2(su-config-bgp)->bgp router-id 192.168.100.20
PE2(su-config-bgp)->log-up-down
PE2(su-config-bgp)->neighbor 192.168.100.10 remote-as 64520
PE2(su-config-bgp)->neighbor 192.168.100.10 update-source 192.168.100.20
PE2(su-config-bgp)->neighbor 192.168.100.30 remote-as 64520
PE2(su-config-bgp)->neighbor 192.168.100.30 update-source 192.168.100.20
PE2(su-config-bgp)->address-family vpnv4
PE2(su-config-bgp-af-vpn)->enable
PE2(su-config-bgp-af-vpn)->192.168.100.10 activate
PE2(su-config-bgp-af-vpn)->192.168.100.30 activate
PE2(su-config-bgp-af-vpn)->exit
PE2(su-config-bgp)->exit
PE2(su-config)->exit
PE2(su)->