Setting a Default VLAN for this Role

A default VLAN can be configured for a policy role. A default VLAN will only be used when either a VLAN is not specifically assigned by a classification rule or all policy role classification rules are missed. To configure a default VLAN, enable pvid-status and specify the port VLAN to be used; pvid-status is disabled by default.

Note

Extreme Networks supports the assignment of port VLAN-IDs 1 - 4094. VLAN-IDs 0 and 4095 can not be assigned as port VLAN-IDs, but do have special meanings within a policy context and can be assigned to the pvid parameter (For more information about these two VLAN-IDs, see VLAN Support on Extreme Networks S-, K-, and 7100-Series Switches). Within a policy context:

• 0 - Specifies an explicit deny all
• 4095 - Specifies an explicit permit all

The following example creates a policy profile with a profile-index value of 1 and associates with it a default VLAN with an ID of 7.

System(rw)->set policy profile 1 pvid-status enable pvid 2