Flow Setup Throttling Configuration Example

The FST configuration example presented here will provide a single port setup example for each port classification type. The baseline has been determined for each port as described in section Determining a Port Classification Flow Baseline. To determine the low-limit, the baseline is increased by 15%. To determine the high-limit, the baseline is increased by 60%.

All limit1 actions will be configured for notification only. Limit2 actions are:

The configuration components used in this example are two S- or K-Series chassis, a PC, a wireless access point, and a server.

See FST Configuration Example Overview for an overview of this FST configuration example.

Click to expand in new window
FST Configuration Example Overview
Graphics/FSTConfigExample1.png

The configuration example assumes the default action configuration list of notify only for action1 and disable and notify for action2. Therefore:

  • There is no need to make any configuration changes for action1 since action1 is always set to notify and that is the default.
  • For action2, when either notification or disable are configured actions, there is no need to set these actions. For notification only actions, disable will be cleared. When drop is the configured action, drop is added and disable is cleared.