Using WebView

By default, WebView (Extreme Networks‘ embedded web server for device configuration and management tasks) is enabled on TCP port number 80 of the S- K- or 7100-Series device. You can verify WebView status, enable or disable WebView, and reset the WebView port.

WebView Configuration describes how to configure WebView on an S- K- or 7100-Series device.

WebView Configuration

Step	Task	Command(s)
1	Enable WebView	set webview {enable | disable}
2	If necessary, change the TCP port for WebView from the default (port 80).	set webview port port
3	Display WebView status to verify your changes.	show webview