Initial Configuration

To initially configure the S- K- or 7100-Series device, you must have connected a terminal to the local console port as described in the Hardware Installation Guide for your S- K- or 7100-Series device. Initial Setup contains the steps to assign an IP address and configure basic system parameters. For information on the command syntax and parameters, refer to the online help or the S-, K-, and 7100 Series CLI Reference Guide.

Note

Note

When configuring any string or name parameter input for any command, do not use any letters with diacritical marks (an ancillary glyph added to a letter). Diacritical marked letters are not supported by SNMP.
Click to expand in new window

Initial Setup

Step Task Command(s)
1 Log in as an administrator.
  • At the login prompt, enter admin.
  • Press [Enter] for the password (no password string by default).
2 For security, change the password. set password
3 Optionally, check the version of the firmware image then check the Extreme Networks web site to verify that you have the latest version. show version
4 Optionally, define a name for the system, the location of the system, and contact information for system issues. set system name [string]

set system location [string]

set system contact [string]

5 Optionally, define a message that displays whenever a user logs in. set banner {motd | login} message
6 Optionally, change the default prompt. set prompt “prompt_string”
7 Display the system‘s setting for the date and time. If necessary, change the setting.
Note: Instead of manually setting the time, you can configure the system as an SNTP client, as described in SNTP Overview.
show time

set time [mm/dd/yyyy] [hh:mm:ss]

8 Assign a management IP address. set ip interface

set ip address

9 If desired, configure additional user accounts and passwords. Up to 32 user accounts may be registered with the local database. set system login username