Displaying CoS Violations (S-, K-Series)

CoS violations can be displayed per physical rate limit for IRL, ORL, and flood control to show you when an rate limit has been violated. Use the show cos violation command to display ports that have a limiter violated as well as any ports that may be disabled by the limiter.

The following example displays default values for the show cos violation irl command output:

System(rw)->show cos violation irl ge.1.1:*
              Rate-Limiter        Rate-Limiter  Rate-Limiter
Port          Index         Type  Status        Counter
------------  ------------  ----  ------------  --------------------
ge.1.1        0             irl   not-violated  0
ge.1.1        1             irl   not-violated  0
ge.1.1        2             irl   not-violated  0
ge.1.1        3             irl   not-violated  0
ge.1.1        4             irl   not-violated  0
ge.1.1        5             irl   not-violated  0
ge.1.1        6             irl   not-violated  0
ge.1.1        7             irl   not-violated  0
ge.1.1        8             irl   not-violated  0
ge.1.1        9             irl   not-violated  0
ge.1.1        10            irl   not-violated  0
...
ge.1.1        29            irl   not-violated  0
ge.1.1        30            irl   not-violated  0
ge.1.1        31            irl   not-violated  0

Violations are also displayed by resource and port using the show cos port-resource command. Violating ports are displayed at the end of the resource table.