Linecard Phantom Configuration (K-Series)

Phantom configuration, a K-Series feature, allows for the configuration of a chassis slot for a specified module model prior to inserting the module, as though the specified module model was present in the slot. Once the specified module is inserted into the slot, any phantom configuration that exists is pushed on to the inserted module. If the module inserted does not agree with the module specified in this command, the phantom configuration is cleared, and you perform a standard configuration on the module.

Note

Because a phantom configuration is cleared when inserting a non-phantom configured module, it is recommended that you save your phantom configuration in case the wrong module type is accidentally inserted.

To configure a chassis slot for phantom configuration see Phantom Configuration (K-Series).

Phantom Configuration (K-Series)

Step	Task	Command(s)
1	To configure a chassis slot for phantom configuration.	set linecard slot-num model
2	To display the model number of linecards either installed or phantom configured on the chassis.	show linecard
3	To clear phantom configuration on a chassis slot	clear linecard slot-num