Implementing Link Aggregation

To implement link aggregation:

• Enable LACP on the network device
• Optionally set a non-default system priority for the device
• Optionally change the administratively assigned key for each port on the device
• Optionally enable single port LAGs on the device
• Enable LACP port active state on all ports that will take part in link aggregation
• Optionally change LAG parameters on each port
• Optionally change how flows will behave when changes take place to the LAG
• Optionally change the load balancing behavior for flows over the LAG
• Optionally assign static ports to a LAG when the partner device only supports a non-LACP method of aggregation