Displays the MPLS contents of the IP routing table.
lsp_name | Specifies an LSP name. |
vlan_name | Specifies a This command is available on the ExtremeSwitching X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches. name. |
permanent | Specifies permanent routing. |
ip_address | Specifies an IP address. |
netmask | Specifies a subnet mask. |
unicast | Displays unicast routes. |
vrname | Specifies a VR or VRF. |
N/A.
A c flag in the Flags column indicates a compressed route resulting from enabling compression using the enable iproute compression command. The total number of compressed routes is also shown.
All routes that are provided to the FIB display the f flag.
If you do not specify a VR or VRF, the command applies to the current VR context.
The following example example displays detailed information about all IP routing:
Switch.3 # show iproute mpls
This command was first available in ExtremeXOS 12.2.2.
This command is available on ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches.