Configures the IGMP timers.
query_interval | Specifies the interval (in seconds) between general queries. |
query_response_interval | Specifies the maximum query response time (in seconds). |
last_member_query_interval | Specifies the maximum group-specific query response time (in seconds). |
vlan_name | Applies the configuration only to the specified This command is available on the ExtremeSwitching X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches.. If no VLAN is specified, the configuration applies to all VLANs. |
vr_name | Specifies the VR to which the configuration should be applied. If no parameter is specified, the configuration is applied to the current VR context. |
robustness | Specifies the degree of robustness for the network. |
Timers are based on RFC2236. Specify the following:
The following command configures the IGMP timers:
configure igmp 100 5 1 3
This command was first available in ExtremeXOS 10.1.
This command is available on platforms that support the appropriate license. For complete information about software licensing, including how to obtain and upgrade your license and which licenses support the IPv4 multicast feature, see the ExtremeXOS 32.1 Feature License Requirements document.