Configures the LLDP port to advertise or not advertise MED power requirement details. This TLV can only be enabled on a This command is available on the ExtremeSwitching X440-G2, X450-G2, X460-G2, X620, and X465 series switches.-capable port and is used for advanced power management between the MED network connectivity and endpoint devices.
all | Specifies all ports on the switch. |
port_list | Specifies one or more ports or slots and ports. |
advertise | Specifies to send the information to neighbors. |
no-advertise | Specifies not to send the information to neighbors. |
No advertise.
When enabled, this LLDP MED TLV advertises fine-grained power requirement details about PoE settings and support. This TLV can be enabled only on a PoE-capable port; the switch returns an error message if this TLV is configured for a non-PoE-capable port.
You must configure the LLDP MED capabilities TLV before configuring this TLV. Configure the LLDP MED capabilities TLV using the configure lldp ports [all | port_list] [advertise | no-advertise] vendor-specific med capabilities command.
As with all the LLDP MED TLVs, the switch sends this TLV only after it detects a MED-capable device on the port. The switch does not automatically send this TLV after it is enabled; the switch must first detect a MED-capable device on the port.
Note
For additional information on power support, see the configure lldp ports vendor-specific dot3 power-via-mdi command.
Power type
Set to PSE.
Power source
Set to primary power source.
Power priority
Taken from PoE port configuration.
Power value
Taken from PoE port configuration.
The following command configures all ports to advertise MED power information to neighbors:
configure lldp ports all advertise vendor-specific med power-via-mdi
This command was first available in ExtremeXOS 11.5.
This command is available on ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches.