Enables OSPF on one or all This command is available on the ExtremeSwitching X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches.s (router interfaces).
vlan-name | Specifies a VLAN name. |
all | Specifies all VLANs. |
area-identifier | Specifies the area to which the VLAN is assigned. |
passive | Specifies to stop sending and receiving hello packets on this interface. |
Disabled.
Not applicable.
The following command enables OSPF on a VLAN named accounting:
configure ospf add vlan accounting area 0.0.0.1
This command was first available in ExtremeXOS 10.1.
This command is available on platforms with an Advanced Edge or Base license, or higher, as described in the ExtremeXOS 32.1 Feature License Requirements document.