show ipv6 dad

show ipv6 dad {[{{vr} vr_name {ip_address} | vr all | [ { vlan } vlan_name | vlan vlan_list ] {tentative | valid | duplicate} | {{vr} vr_name} ipaddress] | {tunnel} tunnel_name}

Description

Displays the configuration and run time status for the DAD feature on the specified IPv6 interface.

Syntax Description

vr_name Specifies a VR for which to display the DAD information.
ip_address Specifies an IPv6 address for which to display the DAD information.
vlan_name Specifies a This command is available on the ExtremeSwitching X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches. name for which to display the DAD information.
vlan_list Specifies a VLAN list of IDs to display the DAD information.
tentative Displays information for IPv6 interfaces for which the status is up and the DAD check is incomplete.
valid Displays information for IPv6 interfaces for which the status is up, the DAD check is complete, and no duplicate IPv6 addresses were detected.
duplicate Displays information for IPv6 interfaces for which the status is down because a duplicate IPv6 address was detected.

Default

If you do not specify a VR or VRF, the command applies to the current VR context.

Usage Guidelines

The vr all option displays DAD information for all IPv6 interfaces on the switch.

Example

The following example displays the DAD feature status for all interfaces in the current VR context:

IPv6 Duplicate Address Detection

DAD Status                 : On
Max Solicitation Attempts  : 1

Virtual Router                   Interface                        Flags Failures IP Address
-------------------------------- -------------------------------- ----- -------- --------------------------------
VR-Default                       vwest                            DlE-U        1 fe80::204:96ff:fe99:1424%vwest
VR-Default                       vwest                            -lE-U        0 fe80::1%vwest
VR-Default                       vwest                            --E-U        0 2010::1

Flags: (D) Duplicate address detected, (E) L2 Interface enabled,
       (l) Link-local address, (L) Loopback enabled,
       (t) Tentative due to the lack of a valid link-local address,
       (T) Tentative address, (U) L2 Interface up

History

This command was first available in ExtremeXOS 12.6.

The vlan_list variable was added in ExtremeXOS 16.1.

The Conflict MAC heading was removed and Interface Failures heading added; the P (prefix address) flag was removed and the l (Link-local address) was added; the t flag was renamed (tentative due to the lack of a valid link-local address); and the detail option was removed in ExtremeXOS 30.1.

Platform Availability

This command is available on ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches.