Displays the BFD session information for a specified client.
bgp | BGP |
mpls | Specifies an MPLS client. |
ospf | OSPF protocol. |
ipv4 | Displays sessions requested by IPv4 version client, e.g. OSPFv2 (Default). |
ipv6 | Displays sessions requested by IPv6 version client, e.g. OSPFv3. |
static | Specifies a static route. |
vrname | Specifies the name of the virtual router. |
IPv4.
Use this command to display session information for a specified client.
The following command displays the BFD sessions for an MPLS client on all VRs:
# show bfd session client mpls vr all
Following is sample output from this command:
Neighbor Interface Detection Status --------- -------- --------- ----- 10.10.10.2 vlan10 3000 Up =============================================== NOTE: All timers in milliseconds.
This command was first available in ExtremeXOS 12.4.
Support for BFD protected static route was added in ExtremeXOS 12.5.3.
The ospf keyword was added in ExtremeXOS 15.3.2.
Support for border gateway protocol (BGP) was added in ExtremeXOS 21.1.