In an Extended Edge Switching topology, removes the bridge port extender (BPE) slot assignment applied to an This command is available on the ExtremeSwitching X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches. identifier on the specified MLAG peer when the port connected to the BPE is physically connected to the MLAG peer switch.
vpex | Specifies Virtual Port Extender (VPEX). |
mlag-id | Specifies a unique MLAG identifier of the MLAG port attached to the bridge port extender (BPE). |
mlag_id | Specifies the MLAG identifier value of the MLAG port attached to the BPE. Range is 1–65,000. |
slot | Specifies unconfiguring the slot identifier for the attached BPE. |
N/A.
The configure vpex mlag-id mlag_id peer peer_name slot slot_num command allows the MLAG peer that does not have a port in the specified MLAG to declare a Extended Edge Switching slot on that MLAG. This command enables you to unconfigure a previously declared slot on that MLAG.
# unconfigure vpex mlag-id 11 slot
This command was first available in ExtremeXOS 22.7.
This command is available on ExtremeSwitching X465 and X590 series switches.