Displays information about SNMPv3 target addresses enhanced or standard mode.
hex_addr_name | Specifies an identifier for the target address. The value is to be supplied as a colon separated string of hex octets. |
addr_name | Specifies a string identifier for the target address. |
N/A.
Use this command to display entries in the SNMPv3 extremeTargetAddressExtTable.
The following command displays the entry for the target address named A1:
show snmpv3 extreme-target-addr-ext A1
The following is sample output from this command:
x670.26 # show snmpv3 extreme-target-addr-ext Target Addr Name : v1v2cNotifyTAddr1 Mode : Enhanced IgnoreMPModel : No UseEventComm : Yes Target Addr Name : v1v2cNotifyTAddr2 Mode : Enhanced IgnoreMPModel : No UseEventComm : Yes Total num. of entries in extremeTargetAddrExtTable : 2
This command was first available in ExtremeXOS 10.1.
The hex_addr_name parameter was added in ExtremeXOS 11.0.
This command is available on ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches.