show inline-power fast ports

show inline-power fast ports {port_list}

Description

Displays fast This command is available on the ExtremeSwitching X440-G2, X450-G2, X460-G2, X620, and X465 series switches. information by port.

Syntax Description

fast Specifies showing fast PoE power status, which is the ability to provide power to devices at the time of switch power on without waiting for boot up based on last saved PoE state.
ports Designates showing fast PoE information for specified ports.
port_list Specifies on which ports to show fast PoE information.

Default

N/A.

Usage Guidelines

This command shows the port level fast PoE configurations saved in hardware, along with the ones currently configured to allow you to see any mismatches. If the default configuration file has never been saved in this boot session, the hardware configurations shown are the initial running configurations from hardware at boot time. If the default configuration file has been saved in this boot session (by save configuration), the hardware configurations shown are the last configurations saved to hardware.

Example

The following example shows fast PoE information on ports 1:1-2, 2:1-5, 3:1-3:

# show inline-power fast ports 1:1-2,2:1-5,3:1-3
Port   State   Enable     Operator Limit   Priority   Detection
----   -----   --------   --------------   --------   --------------------------
1:1    HW      Enabled          28000 mW   Low        802.3af-only
       Cfg     Enabled          28000 mW   Low        802.3af-only
1:2    HW      Enabled          30000 mW   High       4-point legacy-and-802.3af
       Cfg     Enabled          30000 mW   High       4-point legacy-and-802.3af
3:1    HW      Enabled          30000 mW   Critical   802.3af-only
       Cfg     Enabled          30000 mW   Critical   802.3af-only
3:2    HW      Disabled         15000 mW   Low        802.3af-only
       Cfg     Disabled         15000 mW   Low        802.3af-only
3:3    HW      Enabled          30000 mW   High       802.3af-only
       Cfg     Enabled          30000 mW   Low        802.3af-only

History

This command was first available in ExtremeXOS 30.3.

Platform Availability

This command is only available on ExtremeSwitching X465 and X435 series switches.