Configures MAC Security (MACsec) lifetime for port(s).
mka | Configures MACsec key agreement (MKA) parameters. |
life-time | Designates setting the lifetime of potential and live peers. Expiration causes removal from a list, and higher intervals increase MKA protocol stability. |
mka_life_time | Sets the lifetime of potential and live peers. Range is 6-30. Default is 6 seconds. |
ports | Specifies configuring ports. |
port_list | Lists which ports to configure the actor priority on. |
Default value for life-time 6 seconds.
If MACsec link flap occurs, loosen the life-time
equally on
both sides of the MACsec connection.
Note
MACsec link flap is likely to only occur on links connected to lower-end switches (the ExtremeSwitching X620 switch, for example).Important
After enabling MACsec, if you change the MKA lifetime, you must run the configure macsec initialize ports port_list command afterward. Otherwise, the change is not applied.The following configures the MKA lifetime to 10 seconds on port 3:
# configure macsec mka life-time 10 port 3 # configure macsec initialize port 3
This command was first available in ExtremeXOS 31.5.
This command is available on the following platforms:
Note
The MACsec feature requires the installation of the MAC Security feature pack license.Platform | Ports | LRM/MACsec Adapter Required? |
---|---|---|
ExtremeSwitching X460-G2-24p-24hp, X460-G2-24t-24ht switches | Half-duplex, 1G ports (25–48) | No |
All other SFP/SFP+ ports * | Yes | |
ExtremeSwitching X450-G2, X460-G2, X440-G2, X590, X620, and X695 series switches | SFP/SFP+ ports * | Yes |
ExtremeSwitching X465 |
X465-24W, X465-24XE: ports 1–24 X465-48T, X465-48P, X465-48W, X465i-48W: ports 1–48 X465-24MU-24W: ports 25–48 VIM5-4XE: all 4 ports VIM5-4YE in X465-24MU, X465-24MU-24W switches: all 4 ports VIM5-4YE in X465-24W, X465-48T, X465-48P, X465-48W, X464.24S, X465-24S, X465i-48W: first 2 ports only |
No |
Note: * For ExtremeSwitching X460-G2
series switches, the VIM-2X option does not support the
LRM/MACsec Adapter.
|