Configures the TCAM width of a switch.
double | Specifies a double wide ACL TCAM. Provides double wide ACL key with additional qualifiers. |
single | Specifies a single wide ACL TCAM. |
slotNo | Specifies the slot to configure. |
all | Specifies all slots. |
Single.
Use this feature to configure the width of the ACL TCAM key of a slot or switch to be either double wide or single wide.
The switch must be rebooted for the configuration change to take effect.
If you attempt to configure a double wide mode on a slot or switch that does not support it, an error message is displayed.
To display the configured mode, use the show access-list width command.
The following command configures slot 1 to use double wide mode:
# configure access-list width double slot 1
This command was first available in ExtremeXOS 12.5.
This command is available on the ExtremeSwitching X450-G2, X460-G2, X440-G2, X465, X590, X620, and X695 series switches.